To Do 2018

So the 2018 sailing season is rolling around and it time to consider, or reconsider, the things I might want to get done this year. Perusing last year’s list I  notice I hardly added anything from my wishlist. In the end it came down to cost and convenience vs necessity. We are starting to get used to this once-a-year cruise idea and our priorities have shifted a bit. The “toys” are slipping down the list and small conveniences don’t seem to be as important anymore.

The big “issue” for me has always been power. We took almost  2 months off to cruise and, while I admit that we would have preferred to stay and extra night or two in a couple of anchorages, it turns out we had enough battery power to get the most out of most of the anchorages. The early spring weather worked in our favour as we tended to spend 2 or three nights in a place rather than being sucked in my sun and warmth and trying to eke out 4 or 5.  And contrary to expectations the winds were light so we motored enough to keep the batteries charged up without having to resort to marinas too often.

But, be that as it may, we do have a few things to work on this year and a few new things I want to investigate. Being over a 1000 km away from the boat is a pain.

Need to…

  1. The crew at NYCSS replaced the oars on the dinghy and they were too long—rowing was almost impossible…and we like rowing. A couple of minutes with a hacksaw will fix that…if I remember to bring my hacksaw.
  2. I need to check the automatic bilge pump. There was a lot of water in it when we went for that short rainy cruise in October last year. But I didn’t have time to check the switch. I mentioned it to NYCSS but I don’t know if they looked into it.
  3. A rubber seal on port aft locker was coming off. A bit of glue will take care of that.
  4. The hydraulic arms on the fridge and freezer lids were shot so NYCSS removed them for safety reasons. I bought two new replacements and need to install them.
  5. The 30 amp power cord has a burnt end. Which is a pain because we were super careful with it and never had an issue. I guess this is just one of those “charter” things we will have to just swallow.
  6. One of the board supports under the settee had broken loose so the lid sagged. Some glue and a clamp or two will fix that and prevent it from worsening.
  7. I want to measure up my sinks and see if I can get my wood-working brother to make me some custom cutting boards to fit in them.

I am currently waffling over a whole new cord ($100+) or just replacing the end, which would then not be sealed.

Want to…

  1. I really want to check my VHF antenna. I read about a few DIY tests and if necessary I would like to get a SWR Meter. I had replaced a connection below the mast a few years ago but there was a lot of corrosion and while I get decent reception I am suspicious its not as good as it could be.
  2. I really want at least one 12v or USB plug on the binnacle. And while I am at it why not add some to the aft cabin, v-berth and at least one more in the salon. I did something similar to NorthWest Passage before we took her down south so why I haven’t done it for my own boat I really don’t know.
  3. I have been working a lot in stained glass. Why not do a custom piece for the boat? So I would need to find a place and do some measurements, maybe make a template or two.
  4. I want to finally trace & document all the navigation-related and NMEA wiring. It is no use sitting here dreaming if you don’t actually know what is in place on the boat. I spend a lot of time dreaming about adding some cheap wifi… (http://en.usr.cn/Wifi-Serial-Server/WIFI-RS232-RS485-Ethernet-Converter.html).
  5. I am looking into acquiring some kayaks. NYCSS rents them for somewhere around $150/week which makes me conclude I should just buy my own because it will be cheaper in the long run. Or should I try  SUPs (stand-up paddle boards)? I just think some of the more isolated and picturesque anchorages might be nicer to explore by kayak rather than dinghy. Maybe I can rent them out when we aren’t there?
  6. I noticed last year the transducer speedo wheel had a broken paddle. I talked to Ian about it and he said he might have one kicking around. Otherwise I need to grab the spec’s and spend some time find an affordable replacement.

The Dream list…

  • PADI dive certification. I would really like to get the course and pool work done here and then do the dives on the coast this year. It’s a long shot due to costs and scheduling but it’s something that has been on the bucket list for a while.
  • That pesky portable generator. Still on the list. Still waffling. I have been hearing good things about Ryobi’s and they are a couple hundred less than than the omnipresent Honda’s and Yamaha’s so you never know, but it is so unlikely.

Reading other people’s blogs and watching others YouTube videos I realize we really did luck out with this “turn-key boat. When I sift through Yachtworld dreaming about my “forever” sail-around-the-world boat I realize how much investment we would have to make just to get all the stuff I have been  slowly coming to think of as “normal.” I think my next post is going to be about all the things I love about Never for Ever and all the stuff she has. 
—Bruce #Equipment

Leave a Reply

Your email address will not be published. Required fields are marked *